Installation; Main Function - Nicols ZAP LED DMX Manuel D'utilisation

Please use a 3 pin XLR cable/plug when connecting them together.
3 Channels mode:
3 CHs, 9CHs, 28CHs
Light Source:
Total 84pcs, Red: 21pcs, Green: 21pcs,
Blue: 21pcs, White: 21pcs
Voltage: 100V-240V~50/60Hz
Power: 12 W
Fuse : 6.3A
•
Dimension: 320 x 246 × 1 04mm
Weight: 2 kg

3. Installation

The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is
firmly fixed to avoid vibration and slipping while operating. Always ensure that the structure
to which you are attaching the unit is secure and is able to support a weight of 10 times of
the unit's weight. Also always use a safety cable that can hold 12 times of the weight of the
unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out
of the touch of people and has no one pass by or under it.

4. Main Function

To select any functions, press MENU button until the required one is shown on the display.
Select the function by ENTER button and the display will blink. Use DOWN and UP button to
change the mode. Once the required mode has been selected, press ENTER button to
setup or it will automatically return to the main functions without any change after idling 10
seconds. Back to the functions without any change press MENU button. The main functions
are shown below:
16-
DMX 512 Address Setting
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX 512 address.
Once the address has been selected, press ENTER button to setup or automatically return
to the main functions without any change after 10 seconds. Back to the previous functions
without any change press MENU button.
Channel mode
Press the MENU button up to when the
is shown on the display. Pressing ENTER
is shown on the display. Pressing ENTER
17-