Stand Alone Operation; Test Function - Nicols STROB 3000 DMX Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

F. STAND ALONE OPERATION
Turn the fixture ON
-
MODE dipswitches : set #1 ON, #2 to #5 OFF, #6 ON for low-power operation or OFF for high-
-
power operation.
Select either a flash rate or the blinder effect. You set a flash rate by setting the value with pins 1-
-
8 of the ADDRESS dipswitches (see chart below). The value required to achieve a desired flash
rate can be calculated as follows.
To achieve a flash rate of 10 flashes per second on a 50 Hz power supply, the DIP value is 251.
-
To select the blinder effect, set pin 9 ON.
-
Set DIP #10 OFF for normally off operation, or ON for normally on.
-
G. TEST FUNCTION
Start operating TEST function when set pin 3 of the MODE dipswitch to ON. No matter if STROB 3000
DMX has DMX512 signal input from controller, it will automatically test the light intensity/speed and
blind effect of the lamp.

Publicité

Table des Matières
loading

Table des Matières