Pelgrim MAG824RVS Notice D'utilisation page 27

REMOVING AND CLEANING THE WIRE
GUIDES
Only use conventional cleaners to clean the guides.
After cleaning, re-tighten the screws on the guides with a
screwdriver.
When replacing the wire guides, make sure you mount them on
the same side they were installed on prior to removal.
1
Undo the screw. Use a screwdriver.
2
Remove the guides from the holes in
the back wall.
Take care not to lose the spacers fitted on
the wire guides. Replace the spacers after
cleaning; otherwise, sparks may appear.
27