Petsafe Guardian Anti-Bark Collar Manuel D'utilisation page 8

To assure a proper fi t, please follow these steps:
1. Make sure that the batteries are not installed in the
Anti-Bark Collar.
2. Start with your dog standing comfortably (A).
3. Place the Anti-Bark Collar high on your dog's
neck close to the ears. Center the Contact Points
underneath your dog's neck, touching the skin (B).
Note: It is sometimes necessary to trim the hair around
the Contact Points to make sure that contact is consistent.
4. Check the tightness of the Anti-Bark
Collar by inserting one fi nger between
the end of a Contact Point and your
dog's neck (C). The fi t should be snug
but not constricting.
5. Allow your dog to wear the Anti-Bark
Collar for several minutes then recheck
the fi t. Check the fi t again as your dog becomes more comfortable with the
Anti-Bark Collar.
6. Trim the collar as follows (D):
a. Mark the desired length of the Anti-Bark Collar with a pen. Allow for
growth if your dog is young or grows a thick winter coat.
b. Remove the Anti-Bark Collar from your dog and cut off the excess.
8
B
1-800-732-2677
YES
A
NO