Braun 7 Serie Mode D'emploi page 6

6
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. The contacts
shaver will align with the contacts
cleaning station. Important: The shaver
needs to be dry and free from any foam or
soap residue!
If required, the Clean&Renew station will
automatically charge the shaver. The hygiene
status of the shaver will also be analyzed and
one of the following cleaning program indicators
5
will light up:
shaver is clean
short economical cleaning required
normal level of cleaning required
high intensive cleaning required
If the station selects one of the required
cleaning programs, it will not start unless you
press the start button
results, we recommend cleaning after each
shave.
Whilst cleaning is in progress, the respective
cleaning program indicator will blink. Each
cleaning program consists of several cycles,
where cleaning fluid is flushed through the
shaver head and a heat drying process dries
the shaver. Depending on the program selected
the total cleaning time will range from 32 to
43 minutes.
The cleaning programs should not be inter-
rupted. Please note that whilst the shaver is
drying, the shaver head may be hot and wet.
When the program is finished, the blue
indicator will light up. Your shaver is now clean
and ready for use.
Fast cleaning
Push the fast clean button
clean program without drying. This program
takes about 25 seconds only and is recommended
when you do not have time to wait for one of the
automatic cleaning programs. If you remove the
shaver just after the program has finished, wipe
off the shaver head with a tissue to avoid
dripping.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators
of the Clean&Renew station turn off.
u
on the back of the
3
in the
4
. For best shaving
D
to activate the fast