Braun 7 Serie Mode D'emploi page 11

Shaver turns
off with fully
charged bat-
tery.
Battery seg-
ments in the
display are
skipped with
decreasing bat-
tery capacity.
Shaving parts
have been
changed
recently but
replacement
symbol lights up.
CLEAN&RENEW STATION
Shaving system
is still wet after
cleaning Pro-
gram has been
completed.
Cleaning does
not start when
pressing the
start button.
Increased con-
sumption of
cleaning fluid.
Guarantee
We grant a 2 year guarantee on the product commencing on the date of
purchase. Within the guarantee period we will eliminate any defects in the
appliance resulting from faults in materials or workmanship, free of charge
either by repairing or replacing the complete appliance at our discretion.
This guarantee extends to every country where this appliance is supplied by
Braun or its appointed distributor.
This guarantee does not cover: damage due to improper use, normal wear
and tear (e.g. shaver foil or cutter block) as well as defects that have a
negligible effect on the value or operation of the appliance. The guarantee
becomes void if repairs are undertaken by unauthorised persons and if
original Braun parts are not used.
To obtain service within the guarantee period, hand in or send the complete
appliance with your sales receipt to an authorised Braun Customer Service
Centre (address information available online at www.service.braun.com).
For UK only:
This guarantee in no way affects your rights under statutory law.
Foil and cutter are worn
which requires more
power than the motor
can deliver. The appli-
ance turns off.
Foil and cutter are worn
which requires more
power for each shave.
Reset button has not
been pushed.
1. Drain of the
Clean&Renew station
is clogged.
2. Cleaning cartridge
has been used for
quite a while.
1. Shaver is not placed
properly in the
Clean&Renew station.
2. Cleaning cartridge
contains not enough
cleaning fluid (dis-
play lights red).
3. Appliance is in
stand-by mode.
Drain of the
Clean&Renew station
is clogged.
– Renew Foil & Cutter cassette.
– Regularly oil the shaving sys-
tem, especially when cleaning
with water only.
– Renew Foil & Cutter cassette.
– Regularly oil the shaving sys-
tem, especially when cleaning
with water only.
– Push the reset button for at
least 3 seconds to reset the
counter.
1. Clean the drain with a wooden
toothpick. Regularly wipe the
tub clean.
2. The ethanol/isopropanol pro-
portion has decreased while the
oil proportion has increased.
Remove residue with a cloth.
1. Insert shaver into the
Clean&Renew station (contacts
of the shaver need to align with
contacts in the station).
2. Insert new cleaning cartridge.
3. Press start button again.
– Clean the drain with a wooden
toothpick.
– Regularly wipe the tub clean.
11