Operating Elements; Manual Pressure Regulation; Operating Modes - Emerson AVENTICS SentronicD Manuel D'installation

GB
1.2

OPERATING ELEMENTS

8
6
1
⇒
3
2.1
7
1.3 MANUAL PRESSURE REGULATION (HAND)
After an interruption in the power supply, press both arrow buttons located beneath the display during power
up to switch to the manual mode. The operating mode is indicated by the letters "H n d" in the display.
The "H n d" display disappears when the arrow buttons are released.
Press the left arrow button or DOWN arrow to reduce the outlet pressure, press the right arrow button or UP
arrow to increase the outlet pressure. The yellow LED is on permanently during manual mode.
Exit this operating mode by pressing both arrow buttons simultaneously or by turning off the power supply
for a short time.
1.4

OPERATING MODES

Shut-off:
If the setpoint falls below 0.5 %, the coil current is switched off and the valve is fully exhausted.
Overtemperature:
If the temperature of the internal control electronics exceeds 100°C, the operating mode is switched to AU-
TOSAFE and the green LED starts to flash.
Undervoltage / overvoltage:
If the supply voltage is less than 20 V or more than 30 V, the coil current is switched off and the valve is fully
exhausted. The red LED lights up constantly to indicate undervoltage or flashes to indicate overvoltage.
Autosafe:
If the coil current exceeds 1000 mA (DN8) or 560 mA (DN4) for more than 20 seconds, the output current is
limited to max. 70% every 4 seconds to prevent the valve from overheating. The yellow LED flashes.
6
1
9.1 9.2 9.3
2.2
2
⇒
5
10
4
3
⇒
2.3
Visit our website at Emerson.com/AVENTICS
INSTALLATION
1 Proportional solenoid coil
2.1 Pressure supply
2.2 Pressure outlet
2.3 Exhaust
3 Power supply, M12 connector
4 Operator buttons
5 3-digit display of outlet pressure
6 Ground connection, M4
7 Threaded mounting holes M4/6 mm
8 Mounting holes for M4 screws
9.1 Green LED
OFF: Setpoint ≠ feedback
ON: Setpoint = feedback
Flashing: Overtemperature
9.2 Yellow LED
OFF: Normal
ON: Manual operation
Flashing: AUTOSAFE enabled
9.3 Red LED
OFF: Normal
ON: Low voltage
Flashing: Overvoltage
10 Serial communication (PC connection)