Kohler K-3437 Guide D'installation page 3

Scrape off the old
wax seal
1. Remove the Existing Toilet
Turn off the water supply.
Flush the toilet, then sponge out all remaining water from the
tank.
Disconnect the supply shut-off valve (if present), and remove the
old tank and bowl.
Remove the old wax seal from the floor with a putty knife.
Replace the old T-bolts with the new 5/16" diameter T-bolts.
CAUTION: Risk of hazardous gases. If the new toilet is not
installed immediately, temporarily stuff a rag in the closet flange.
Kohler Co.
T-Bolt
Closet
Flange
3 1021801-2-A