Publicité
Les langues disponibles
Les langues disponibles
• Always insert the correct size and type of drill or screwdriver.
• Set the direction switch (2) to the correct direction.
• Never change the direction of motion when the machine is switched on.
Never use excessive force when drilling. Too much pressure reduces the
speed of the machine, and the required power is greatly reduced. This may
result in overload, which can damage the motor of the machine. When the
machine becomes too hot, allow it to run for two minutes without a load and
then interrupt working for a short time. Clean the machine with a clean cloth
and a brush. Ensure that the ventilation slits are not blocked.
Warning: Always use the additional grips which come with the appliance.
Losing control of the appliance may result in injuries.
Always disconnect the device before performing any adjustment or
maintenance operation. If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a qualified repair
person (always replace the two brushes at the same time).
waste but that it shall be returned to a collection system which
conforms to the European WEEE Directive. Contact your local
authorities or stockist for advice on recycling. It will then be
recycled or dismantled in order to reduce the impact on the
environment. Electric and electronic equipment can be hazardous
for the environment and for human health since they contain
hazardous substances.
This product t shall not be discarded with household
Publicité
