Joie Traver shield Mode D'emploi page 3

WARNING
!
Do take care to locate and install the booster so
that it is not liable to become trapped by a move-
able seat or in a door of the vehicle.
!
This booster is designed ONLY for child weighing
9-36kg (approximately 1-12 years or under).
!
Any straps of vehicle seat should be tightened
and not twisted.
!
Failure to properly use this booster increases the
risk of serious injury or death in a sharp turn,
sudden stop or crash.
!
DO NOT use another manufacturers soft goods
with this booster. See your retailer for Joie re-
placement parts only.
!
DO NOT use in any configuration not shown in the
instructions.
!
NEVER leave your child unattended.
!
NEVER give this booster to someone else without
also giving them this manual.
!
DO NOT modify your booster or use any accesso-
ries or parts supplied by other manufacturers.
!
After your child is placed in this booster, the
safety belt must be used correctly, and ensure
that any lap strap is worn low down, so that the
pelvis is firmly engaged.
!
Replace the booster after an accident of any kind.
An accident can cause damage to the booster
that you cannot see.
1
WARNING
!
NEVER leave a booster unsecured in your vehicle.
An unsecured booster can be thrown around and
may injure occupants in a sharp turn, sudden stop
or crash. Remove it or make sure that it is secure-
ly belted in the vehicle.
!
NEVER leave luggage or other objects unsecured
in a vehicle, they are liable to cause injuries in the
event of a collision.
!
NEVER use a booster if it has damaged or missing
parts. DO NOT use a cut, frayed or damaged
vehicle seat belt.
!
The booster can become very hot if left in the sun.
Contact with these parts can burn your child's
skin. Always touch the surface of any metal or
plastic parts before putting your child in the
booster.
!
NEVER use a second-hand booster or a booster
whose history you do not know.
!
DO NOT use this booster without the soft goods.
!
The soft goods should not be replaced with any
besides the ones recommended by the manufac-
turer, because the soft goods constitute an inte-
gral part of the booster performance.
!
DO NOT use any load bearing contact points
other than those described in the instructions and
marked on the booster.
!
DO NOT face your booster toward the rear of the
vehicle.
2