Suntec Wellness Klimatronic Heat Patio 2000 Mode D'emploi page 9

• The device may only be operated connected to ground.
• Please keep the device away from flammable materials.
• Please allow the unit to cool completely before you
clean or move it.
• Do not attempt to repair, disassemble or change the
o the appliance by yourself.
Warning:
not cover the heater!
Important: This heater is equipped with a temperature
control unit. Please do not operate the unit near people
who cannot move independently be, unless they are
supervised throughout.
Installation
Please place the device on the head (Figure A). Connect the plug and the power cord through the holes in
•
the center of the base cover and the base.
Please fix the base to the heater using the screws (4x M6*30).
•
Commissioning
• Operating voltage: 220-240V~, 50Hz, 2000W
• Please connect the unit to the power.
• Please return the power switch (on the top
the unit) in the "I" position; P0 is shown on the display.
• Please press the "
Low (P1 wird auf dem Display angezeigt),
medium (P2 wird auf dem Display angezeigt)
High (P3 wird auf dem Display angezeigt).
• Please press the timer button to set a timer from 0-24 hours
• Please press the button "OFF" to disable the device.
• Please return the switch to the "O" position.
Remote control (B)
With the supplied remote you can control the device as follows:
Please bring the main switch (on top of the unit) in the "I" position to put the unit into standby mode.
Please press the respective buttons on the remote control to choose between the heating levels and the timer:
1: On/Off
P1: Low
P2: Medium
P3: High
Timer: Timer
Please bring the main switch in the "O" position to turn off the device.
In order to avoid overheating, do
" button to switch between the following heat settings:
9