Key Functions; Operation Procedures - Sunny Health & Fitness 012-S Mode D'emploi

KEY FUNCTIONS:

MODE: Press the MODE button to select a function.
(Time, Reps/Min, Count, Calorie and Scan)

OPERATION PROCEDURES:

AUTO ON/OFF:
1.
If the steps of the machine are put into motion or the MODE button is pressed, the meter will
activate and will remain active during use. If it goes without signal for approximately 4 minutes,
the meter will turn off automatically.
RESET:
2.
The meter can be reset by pressing and holding the MODE button for three seconds. Removing
the batteries will also reset the meter and return all function settings back to zero.
MODE:
3.
To select the LOCK MODE setting, press the MODE key when the pointer is on the function you
wish to lock. Once locked, only the selected function will be displayed.
FUNCTIONS:
4.
TIME: Counts the total time of an exercise from start to finish.
CALORIES: Counts the number of total calories burned during an exercise from start to finish.
COUNT: Automatically accumulates the count of steps taken during sessions. Meter counts 1 step
after you step once with each foot.
REPS/MIN: Automatically displays the count of steps per minute.
SCAN: Press the MODE button until the indicator arrow points to SCAN. The indicator arrow will
continue to flash indicating that SCAN mode is active. SCAN mode will automatically scan
through each function in sequence.
NOTE:
1. If you have an inaccurate reading on the meter, please replace the battery immediately. (See
instructions below)
2. Please use (1) LR44, 1.5V battery.
3. The meter is auto-powered. It turns on when exercise begins, and it turns off when no movement
is made between 4 to 5 minutes.
4. All functions will automatically stop calculating when "STOP" appears in the upper left corner of
the meter. This occurs when there is no signal for a period of 4 seconds. Once the exercise
begins again, the meter will automatically start recalculating.
EXERCISE METER
10
Version:2.3