Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WIRE INSERTING HOLE
1.
Remove Meter (No. 12) from Main Frame (No. 10) and disconnect the link wire of Sensor
(No. 13) from the Meter (No. 12).
2.
Remove the plastic cap from the battery seat.
3.
Remove the battery using your fingers.
4.
Insert the new battery using your fingers. Ensure that the positive side of the battery which
is labeled with a + sign is facing upward once the new battery is in place.
5.
Place the plastic cap over the battery seat.
6.
Insert the link wire of Sensor (No. 13) onto the wire inserting hole on the back of Meter (No.
12).
7.
Insert the Meter (No. 12) onto Main Frame (No. 10).
CHANGING THE BATTERY
PLASTIC CAP
BATTERY
PLASTIC CAP
BATTERY SEAT
MAIN FRAME
9
12
BATTERY
13
Publicité
Table des Matières
