shark SM200 Serie Manuel Du Propriétaire page 8

Getting Started - cont.
4 Turn the water tank cap counter clockwise and
remove from the tank. (Fig. 4)
Use the filling flask to pour water into the tank.
Do not fill past the fill line on the water tank.
(Fig. 5)
5
After filling the tank, replace the water tank
cap by placing back on the tank and turning it
clockwise until tight.
IMPORTANT: Do not use on unsealed wood
or unglazed ceramic floors. On surfaces that
have been treated with wax or some no wax
floors, the sheen may be removed by the heat
and steam action. It is always recommended to
test an isolated area of the surface to be cleaned
before proceeding. We recommend that you
check the use and care instructions from the
floor manufacturer.
4 TOLL FREE: 1-800-798-7398
fig. 4
fig. 5
Calcium and mineral deposits can build up and
impact the performance of your steam mop
over time. To extend the life of your product we
recommend that you use distilled water.
fig. 6
ATTACHING THE MOP PAD
1 Fit one side of the Sonic Lift
the head first, making sure that the scrubbing
side is facing down, then using the lavender
loop, pull the pocket over the head. Attach the
hook and loop quick fasteners on the top of the
pocket to secure in place. (Fig. 6)
cleaning pad onto
™