Charging The Battery - shark CORDLESS VERTEX PRO MultiFLEX IZ600 Serie Guide D'utilisation

CHARGING THE BATTERY

USING THE LI-ION CHARGER
LI-ION CHARGER
Plug the Li-Ion Charger into a wall outlet.
IN THE VACUUM: MULTIFLEX®
To put the vacuum in storage mode, press the
MultiFLEX Wand Unlock Latch while folding the
handheld vacuum forward until the wand clicks and
locks. Plug the charger into the charging port on the
handheld vacuum.
s h a r kc l e a n . c o m
IN HANDHELD VACUUM
To charge the battery inside the handheld vacuum,
connect the charger to an electrical outlet, then
insert the charger plug into the port below the
handle on the handheld vacuum.
OUT OF THE VACUUM
If battery is removable (IZ660 and IZ680 Series),
press and hold the Battery Release Button, then
slide out the battery. Plug the charger into the
charging port on the battery. To reinstall the
battery, slide it into the slot in the back of the
handheld vacuum.
POWER ON/OFF
Press power button to turn vacuum on or off.
The unit will not turn on if the charger is
NOTE:
connected. Unplug the charger before turning
on vacuum power.
CARPET SETTING
To vacuum in carpet mode, press the floor select
button until the carpet icon ( ) illuminates. The
brushrolls will spin faster to pick up debris below
the surface of your carpets.
SETTINGS
HARD FLOOR SETTING
To vacuum in hard floor mode, press the floor select
button until the hard floor icon ( ) illuminates. The
brushrolls will spin slowly to clean bare floors and
small area rugs.
SUCTION MODE DISPLAY LIGHTS
Off
Deep Clean
SUCTION POWER MODES
Press the ( ) button to toggle between ECO, Deep
Clean, and Boost modes. To save battery power,
select ECO mode. For everyday cleaning power,
select Deep Clean Mode. For an extra burst of
power, select Boost mode.
sharkclean.com
ECO
Boost