bosal Comfort Pro II Notice D'assemblage Et De Sécurité page 62

Defective parts and straps must be replaced.
The steel parts of the bike carrier are protected in the works against corrosion by
a powder coating. If this paint coating is damaged, please have the damage
rectified professionally as soon as possible.
Please refer to our customer service for the replacement of parts.
Any modification of original parts and materials or the construction of bike carrier
can adversely affect its safety and serviceability.
DISPOSAL
Local regulations must be observed for the disposal of the product.
The packaging should also be sorted by type and disposed of in the relevant
collection containers.
Further information is available from your communal disposal point.
ADJUSTMENT OF THE QUICK CONNECTOR
Carry out this maintenance operation only if the bike carrier cannot be fitted
firmly to the trailer coupling, as described in the chapter "Fitting the bike carrier
to the trailer coupling".
Remove the bike carrier from the trailer coupling, as described under
"Dismantling the bike carrier".
 Loosen the locking nut slightly (fig. 1).
 Screw in the setting screw one quarter of a turn (fig. 1).
 Tighten the locking nut (fig. 2)
 Check whether the carrier is now firmly seated on the trailer coupling, as
described under "Fitting the bike carrier to the trailer coupling". If not, repeat
the above steps.
1 2
62