Télécharger Imprimer la page

HumanTechnik Signolux Série Mode D'emploi page 12

Lampe-flash

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
Delete button:
This button serves to remove
transmitters assigned to an
indicator symbol (see section
3 „Deleting transmitters from
receiver memory").
Setting up the system
1. Connect the device
Plug the »signolux plug-in recei-
ver« into a well visible mains
socket.
The indicator LEDs light up once
and the device is ready to use.
The »signolux plug-in receiver« is
not waterproof. Therefore it is not
advisable to use it in the open.
2. Programming signals and
assignment to the symbols
A transmitter (e.g. doorbell push-
button) can be assigned to each
symbol. This assignment can
be adapted by programming.
Up to 8 transmitters can be as-
signed to each symbol. Please
keep in mind that a transmitter
can only be assigned if it is not
yet known in the memory of the
»signolux-pager«. If required,
you might first have to delete
the transmitter from the memory
(see section 3.)
English 12
a)
Keep the function button
pressed for some time. The
symbols begin to light up in
sequence. Let go of the fun-
ction button as soon as the
desired symbol is lit. (e. g.
doorbell symbol)
b)
Trigger the signal of the
transmitter you want to as-
sign to the lit up symbol. (e.g.
operate the doorbell button).
c)
Wait for about 20 seconds
and test the function.
3. Deleting transmitters from
receiver memory
If you wish to remove the transmit-
ters assigned to a symbol from the
receiver memory:
a)
Keep the function button
pressed for a few seconds.
The symbols begin to light
up in sequence. Let go of the
function button as soon as
the desired symbol is lit.
b)
Now press the function but-
ton and the delete button at
the same time. All symbols
will briefly light up.
Please note that this will dele-
te all transmitters assigned to
the according symbol.

Publicité

loading

Ce manuel est également adapté pour:

Signolux plug-in flash lampA-2644-0A-2644-wA-2644-3