Wallbox Power Sharing Mode D'emploi page 8

INSTALLATION
Preparing the chargers
Power Sharing Cabling
Connecting your chargers for Power Sharing requires installation of communication cabling. This
cabling may be drawn through either of the following pathways:
Center opening
Use the small opening located at the bottom
of the charger between the power input and
the EV connector cable output.
When using this opening for the communica-
tions cabling, first remove the screw plug. Use
a wrench to hold the interior lock nut while un-
screwing the plug using a flathead screwdriver
from the bottom (exterior) side of the plug.
Power input opening
When allowed by local codes, run the data cable
in the same power supply conduit (same conduit
used for the hardwired electrical wiring).
or
8