Wallbox Power Sharing Mode D'emploi page 16

OPERATING
Status
Status Text
PRIMARY CONFIGURED
WITH ALL SECONDARIES
PAIRED
POWER SHARING
ACTIVATED
PRIMARY CONFIGURED
WITH SOME
SECONDARIES NOT
PAIRED
UNCONFIGURED POWER
SHARING
PRIMARY NOT
CONFIGURED
PRIMARY NOT PAIRED
SECONDARY PAIRED
WITH NETWORK
SECONDARY NOT PAIRED
WITH NETWORK
POWER SHARING
ACTIVATED
WAITING ASSIGNATION
Shown in Description
Shows only for Primary charger.
Power Sharing
The network has been successfully set.
app screen
All chargers are connected with the Primary.
The network has been successfully set.
Charger app
home screen
The unit is connected to the primary unit.
Shows only for Primary charger.
The network has been successfully set. Some Secondary units
Power Sharing are not connected.
app screen
Verify that the setting "number of chargers" in Primary unit
coincides with the number of chargers in the system. Check
the CAN bus communications cables between the chargers.
Charger app
This is the initial status after powering on the set-up.
home screen
The unit is paired with the Primary unit but it detects that it is
pending to be configured.
Power Sharing
The chargers will blink in red.
app screen
Shows only for Secondary chargers.
The number of chargers in the configuration are not consistent
Power Sharing
with the ones that are connected with the Primary. Review
app screen
"Configuring the Primary Charger" and ensure all steps are
completed correctly.
Power Sharing Secondary connected with the Primary. The installation has
app screen been successful.
The Secondary chargers are not successfully connected with
the Primary charger on the Power Sharing network. This may
Power Sharing
occur if the system cannot successfully communicate with the
app screen
chargers within 30 seconds.
In this state, the charger LED halo will blink fast and Secondary
chargers will be limited to 6 Amps.
Insufficient power is available to this charger. This may occur
if all available system power is already assigned to other
connected chargers/vehicles.
Charger app
As other vehicles complete charging or are disconnected,
home screen
when the minimum power is available, this charger will begin
charging. The charger LED halo will pulse blue, indicating an
active charging session.
16