Installation; Preparing The Chargers - Wallbox Power Sharing Mode D'emploi

INSTALLATION

Preparing the chargers

Before proceeding with Power Sharing setup, you should install the chargers according to the
instructions as included in the charger's Installation Guide. Note that depending on the type of
charger installation (hardwired or NEMA plug), you will have additional instructions as described
below:
Installation
type
Hardwired
Plug-in
For NEMA plug-in installations, you typically will not have to open the charger; however, to
setup plug-in chargers for Power Sharing, you will need to open each connected charger in
order to perform some of the steps in this set-up. Refer to Pulsar Plus Installation Guide for
more information on how to open the charger.
After you have mounted your charger according to the instructions in the Installation Guide,
ensure:
• The charger cover is not attached to the charger (disconnect the communications cable
from the cover).
• The chargers are electrically wired (connected to a circuit).
• Any connected circuits are NOT powered on during installation.
To make handling of the chargers, cables, and connectors easier during the Power Sharing
setup, you may want to install the holsters before proceeding. See the "Installing the Holster"
section in the charger Installation Guide.
Installation Guide
section
Hardwire Installation
NEMA Plug-in Installation
Steps to be excluded
Closing the charger
Closing the charger
Additional step
to be included
None
None
7