Configuration - Wallbox Power Sharing Mode D'emploi

INSTALLATION

Configuration

Every Power Sharing system consists of one Primary charger and 1 from 24 Secondary chargers.
The Primary charger is the central control unit of the entire system and it is the only unit in the
system that requires unique configuration.
The Primary charger needs to be set as a Terminating (T). The key configuration for the Primary
charger is the Current Selector switch as shown below.
The termination configuration (T) is set by a switch inside the charger (see figure below). If you
anticipate adding chargers to the system in the future, we suggest configuring two chargers as
Terminating (T) and the other chargers as Non-terminating (NT).
Position
0
8
Any other
For Power Sharing installations, the maximum current has to be adjusted through the
myWallbox app and not through the current selector.
For more information on current adjustment through the app, please visit:
https://support.wallbox.com/na/knowledge-base/adjust-the-charging-current/
To ensure a proper set-up, the measured resistance between CAN-H and CAN-L must be
around to 60 Ohms. If it differs from that, recheck the proper wiring and the T/NT configuration.
Configuration
Secondary
Primary
Stand-alone (see Installation Guide)
T
NT
CAN
CURRENT CURRENT
SELECTOR SELECTOR
Primary
Secondary
11