Wallbox Power Sharing Mode D'emploi page 14

SETTING UP
Configuring the Primary Charger
Once you have added the chargers you are connecting to the Power Sharing system, stand in
close proximity to the PRIMARY charger with your mobile device and Bluetooth switched on.
1.
Launch the myWallbox app on your mobile device and log in.
2.
From the list of chargers, select the charger you have setup as the PRIMARY charger.
3.
Click the Configurations (gear) icon and then, from the Configurations screen, select
"Installation Options" and then select Upgrades.
On the Power Sharing screen, you will need to adjust the following settings:
1. Number of chargers. This is the TOTAL
number of chargers in the Power Sharing
system including the Primary charger.
2. Maximum current per system (phase). This
is the maximum amount of power available for
all chargers connected to the Power Sharing
system.
Be reminded that the system must be
connected to a circuit rated to 125% of the
maximum power dedicated to the chargers.
For example, if the total power available to
chargers is 200Amps, the circuit must be
rated to 250Amps.
3. Minimum current per charger. The default
value is set at 6 Amps; however, some vehicles
require a minimum current of 10Amps.
4.
After you have entered all values, click "Save". It may take up to a minute for the system to
complete configuration.
Note that you only will configure the PRIMARY charger as describer into the myWallbox app.
No additional configuration is needed for the Secondary chargers.
1
2
3
14