Building In Dimensions - Asko Hg1654s Mode D'emploi

Building in
Preparing the hob
Fit the elbow supplied on the appliance's gas connection.
Cut opening in worktop
Cut the opening in the worktop. This should be done very
accurately (see building in dimensions). If the woodtop is made
of treated wood, then coat the sawn surfaces of the top with
sealing varnish, to prevent moisture causing the top to swell.
Attachment points for mounting brackets
See 1* in the illustrations of dimensions for Building in for the
attachment points for mounting brackets.
Screw hole for
Thin worktops
mounting bracket
Placing the sealing tape
Remove the protective foil from the sealing tape (A) and apply
the tape around the cut-out in the worktop.

Building in dimensions

Hg1654s
minimum distance between rear of appliance and rear wall:
10 mm
Thick worktops
A
front
15