CDVI UCA3 Manuel D'installation page 13

INSTALLATION MANUAL
UCA3
3-Door standalone controller (Radio/Proximity)
- Press the PROG
PROG
I - PROGRAMMING A MASTER TAG
By programming a master tag, you may limit access to the central unit to the master tag holder only. The master
tag enables access to all doors and only one master tag may be programmed. After recording the master tag,
the enrolment reader information is displayed directly.
- To gain direct access to the enrolment reader information, open the menu 4
- Press the Next key
- Open the menu 4
- Present a tag in front of the reader or select one of the two channels on the RF remote control.
Enrolment is possible on any of the readers (front panel, auxiliary and radio frequency) whatever
the technology. Present a tag on the front panel, insert a magnetic card in the reader, type a code
on the keypad or press one of the two channels on the emitter.
J - TO ERASE OR REPLACE A MASTER TAG
- Press the PROG key to enter the programming mode.
PROG
- Open the menu 4
- Press the Enter key to validate, the LED is steady.
key twice to exit the programming mode.
.
:
The display indicates
The display indicates
is now programmed.
,
The display indicates
The master tag
EN
.
cdvi.com
13
cdvigroup.com