Honda CR-V
03/2002 - ....
Ref. 1349
Fitting instructions
1)
Remove the spare wheel and the inner coating in the trunk.
2)
Remove the bitumenlayer on a level with the fixation points (visible on both sides because of the imprints
in the bottom plate). Drill these holes through with ø10,5mm (there are also imprints in the chassis beam).
Enlarge these holes in the trunk till ø20mm and insert the mounting tubes (g) in them. Place at points (A)
and (C) the mounting plates (h) on top of the tubes and insert the necessary bolts.
Place at point (B) and (D) the enclosed washer and also insert a bolt here.
3)
Now place the mounting pieces (i) and (j) with points (A), (B), (C) and (D) on the already inserted bolts.
Place the safety washers and the nuts, but do not tighten them.
4)
Place the tow bar in between the mounting pieces (i) and (j), make sure that point (F) fits over the towing
ring and that points (E) and (E') of the tow bar fit those of the mounting pieces.
Insert the necessary bolts, washers and nuts and tighten everything firmly (socket plate p comes on point
F).
5)
Install the (*) and also tighten firmly.
Composition
1 tow bar reference 1349
1 ball T45L006
3 bolts M12x65
2 bolts M12x60
4 safety nuts M12
2 mounting tubes T45
2 mounting pieces T45
1 security shackle (v)
1 socket plate P04 (p)
4 bolts M12x35
5 safety washers M12
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
3 nuts M12
(*-F)
4 bolts M10x100
(*)
4 bolts M10x90
(*)
8 safety washers M10
(*)
8 nuts M10
(*)
8 mounting tubes (g)
(*)
2 washers 50x50x12x2
(F)
1 mounting piece (i)
(E-E')
1 mounting piece (j)
(E-E'-F)
2 mounting pieces (h)
All bolts and nuts : quality 8.8
(E'-F)
(C-D)
(A-B)
(A-B-C-D)
(A-B-C-D)
(A-B-C-D)
(B-D)
(C-D-E-E')
(A-B-E-E')
(A-C)