Fermax DUOX PLUS 4S Guide De Mise En Marche Rapide page 9

CONNECTIONS AND SIGNAGE
NOTE: the decoder supports the functions of auto-start, F1, F2, call to the guard unit and second
channel, bearing in mind that only one channel can be active at any one time on each decoder.
Connectors
a) System connection terminals
a1) B, B (INPUT/ OUTPUT):
the power from either of its B B terminals (INPUT) using the other B B as bus output (OUTPUT).
a2) B1, B1 - B2, B2 - B3, B3 - ........ - B4, B4:
can connect a maximum of 3 terminals to each of the 4 outputs.
Status LED for each output: FIXED RED if there is a short circuit problem at the output, voltage
below 15 Vcc or overconsumption (peak consumption greater than 1 A).
b) PGM: programming button.
c) DL (green): power supply LED and operating modes.
OPERATING MODES
Switched off
Rapid flashing
Switched on
Slow blinking
1 flash every 3 seconds
Double flashing
d) SW SWITCH:
switch for selecting the adaptation of the line.
e) DIPSWITCHES: to assign the DIRECTION TABLE to the decoder outputs and set the programming mode.
e1) BLOCK ADDRESS:
• To assign the address of the Block in sequential mode.
• Dip 8 ON + DECODER DIP 8 ON: it activates the window for programming in open mode.
• Dip 8 OFF: it deactivates the window for programming in open mode.
e2) DECODER ADDRESS:
• To assign the decoder output address in sequential programming.
• Dip 8 ON: it activates the open mode, enables open programming mode. Leave ON if this
mode has been used.
e3) OFFSET DIR.:
OFFSET].
f) Silk-screen printing Box to record the addresses of each output.
The device you have purchased is identified under Directive 2012/19/EU on waste electrical and electronic
equipment. More info:
d
c
b
a2
B1
B2
e1
terminals connecting the bus of the input/output riser. The decoder takes
DL
No power or power < 17 Vdc
Not programmed
Standby or parameter synchronization
Receiving commands by the bus or Active communication channel
Remote address programming
Unlocking the installer menu or valid address reception in open mode
to make the address of output 1 of the decoder start from [number chosen at
www.fermax.com.
a1
e3
a2
B3
B4
e2
connection terminals to connect home terminals. You
DECODER/AISLADOR DUOX PLUS 4S
9