SAFETY GUIDELINES
This appliance was produced under strict quality controls.
It complies with all established international safety standards.
Nonetheless, the following instructions should be fully read and
observed in order to prevent any hazard:
Do not open the appliance! Risk of electric shock!
There are no parts in the appliance that require maintenance by the user.
Maintenance/Alterations
All equipment that is connected to the domestic mains
voltage can be dangerous to the user if not handled
properly. Leave maintenance work to qualified profes-
sionals. The product is only permitted for connection
to AC 230Volt/50Hz, for earthed sockets and use in
enclosed areas. Altering the product or manipulating
its serial number voids the warranty. After a fault,
leave the appliance's fuse to be replaced only by a
professional with one of the same kind.
Power Cable Connection
Always pull the plug and never the power cable if
you want to disconnect the appliance from the
mains power. Make sure when setting up the appli-
ance that the power cable is not squashed, severely
bent or damaged by sharp edges. Do not touch the
power lead with wet or damp hands. Use the power
cable supplied or another one from Vincent.
Switching Off
Switch the appliance off every time before you con-
nect or remove other components or loudspeakers,
disconnect or connect it to the mains power, leave it
unused for a longer period or want to clean its outsi-
de. On all amplifiers and receivers, wait approx. 1
minute after this before disconnecting or reconnecting
the cable.
Moisture/Heat/Vibration
Contact of electrically operated equipment with
liquids, moisture, rain or water vapour is dangerous
for such equipment and the user and must be avoi-
Vincent
24
ded without fail. Take care that no liquids or objects
get inside the appliance (ventilation slots etc.).
It must be disconnected from the mains power imme-
diately and examined by a professional if this hap-
pens. Never expose the appliance to high tempera-
tures (direct sunshine) or strong vibration.
Heat Build-up
All amplifiers generate heat as part of their design.
Make sure that a gap of 5 cm remains around the
appliance and that the surrounding air can circula-
te (do not install in enclosed cupboards). Vents must
not be covered up.
Volume
The maximum tolerable volume is always reached well
below the maximum possible setting on the amplifier.
Be careful with the volume setting, therefore, in order
to prevent damage to hearing. So that you do not
ON
expose yourself to high volumes unintentionally, always
set to a low level before changing the input channel.
OFF
Cleaning
Pull out the power plug before cleaning the outside
of the product. Whenever possible, use a soft, lint-
free cloth that has been dampened. Do not use abra-
sives, solvents, thinners, flammable chemicals, polis-
hes and other cleaning products that leave marks.
Batteries
Take note of the instructions for using batteries in
the chapter "Remote Control".
OTHER INSTRUCTIONS
Setting up the appliance
How the system is set up has an effect on the
sound quality. Therefore only place it on a suitab-
le, stable surface. To make the most of your
system's sound quality, we recommend placing the
equipment on Vincent racks and not putting them
on top of each other.
Old electronic equipment
This appliance is subject to the conditions set out
in the European Directive 2002/96/EC, whose
implementation is regulated in Germany by the
Electrical and Electronic Equipment Act (ElektroG).
This is identified by the symbol of a crossed out
waste bin on the appliance.
What this means for you as a consumer:
All old electrical and electronic equipment that is
no longer used must be disposed of separately
from domestic waste using places provided by the
authorities. By doing so you can prevent damage
to the environment and help to encourage manu-
facturers to produce more durable or reusable pro-
ducts. For further information about disposing
your old appliance, please consult your local aut-
hority, waste disposal agency or the shop where
you bought the product.
CE sign
This appliance complies with the current EU direc-
tives about attaining the CE mark and thus meets
the requirements for electrical and electronic
equipment (EMC regulations, regulations and re-
gulations for low voltage equipment).
Declarations
This document was written by Andreas Böer. It is a
product of Sintron Vertriebs GmbH, 76473
Iffezheim and may not be copied or distributed part-
ly or in full without express, written consent.
Vincent is a registered trademark of Sintron Vertriebs
GmbH, 76473 Iffezheim.
Vincent works continually to improve and develop its
products. Therefore, the appearance and technical
design of the appliance are subject to changes, as
long as they are in the interest of progress.
The content of these instructions is for information
purposes only. It can be changed at any time without
prior notice and does not constitute any obligation
on the part of the trademark's owner. The latter assu-
mes no responsibility or liability for errors or inaccu-
racies, which may be included in these operating
instructions.
Storage of the packaging
We strongly recommend that you keep the original
packaging in case you need to transport the equip-
ment again at a later date. Transport damages are
mainly caused by improper packaging of the HiFi-
devices. Because the original packaging fits the
equipment accurately it will reduce the risk of
damage if transport is necessary.
Explanation of the symbols
The lightening bolt tells you that dangerous
voltages are present in the appliance, which
can cause an electric shock.
This symbol brings your attention to
particularly important information regarding
operation and maintenance.
This symbol identifies useful information and
advice about how to handle the appliance.
Vincent
25