Kenwood KDC-BT310U Mode D'emploi page 21

Frequency Response (±3 dB)
Input Maximum Voltage
Input Impedance
Operating Voltage
Maximum Current Consumption
Installation Size (W × H × D)
Weight
Subject to change without notice.
20 Hz to 20 kHz
1 200 mV
10 kΩ
14.4 V (10.5 V to 16 V allowable)
10 A
182 mm × 53 mm × 160 mm
(7-3/16" × 2-1/8" × 6-5/16")
2.9 lbs (1.3 kg)
IC (Industry Canada) Notice
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
The term "IC: " before the certification/ registration number only signifies that the Industry
Canada technical specification were met.
CAUTION
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C
to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very
low levels of RF energy that it deemed to comply without maximum permissive exposure
evaluation (MPE). But it is desirable that it should be installed and operated keeping the
radiator at least 20cm or more away from person's body (excluding extremities: hands,
wrists, feet and ankles). Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful communication.
• Contains Bluetooth Module FCC ID: XQN-BTR60X
• Contains Bluetooth Module IC: 9688A-BTR601
ENGLISH | 21