Error Code Display - Enerwatt EWV-RACER-BK-A Guide D'utilisation

5. In display 3, hold the button (SW) shortly to enter display 1.
6. In each display interface, if you hold the
7. Automatic Prompt Interface

7.1 Error code display

When the electronic control system of the electric vehicle fails, the meter will automatically display (flicker) a fault code.
You can't exit the fault code display until the problem is solved.
Error Code
01 info Throttle abnormality
03 info Motor hall signal abnormality
04 info Torque sensor signal abnormality
7.2 Motor operating temperature alarm
When the motor operating temperature exceeds the warning value, the display will flash to warn you. The controller will offer the appropriate protection to the motor.
GENERAL SETTINGS
1. Maximum Trip Speed
Hold the button (SW) to turn the meter on. After 5 seconds hold the
The speed display column will then flash. Hold the
The default maximum riding speed is 25 km/h. Once you have finished, hold the
5. Exit General Settings
button (SW) for about 2 seconds to exit any one of the three general settings and return to display 1. The current settings will be saved.
Hold the
If the meter isn't used for more than 1 minute, it will automatically return to display 1, and the original settings will be saved.
|
Distribué par Distributed by:
TCED INTL. Inc.
700, chemin du Grand Bernier Nord
Saint-Jean-sur-Richelieu
(Québec) J2W 2H1
3. Display 2
Hold the button (SW) shortly to enter display 2. After riding for 5 seconds, display 1 will automatically appear.
In display 1, the original motor power is replaced by the motor running temperature as shown in the image.
4. Display 3
button (SW) shortly to enter display 3.
Hold the
After cycling for 5 seconds, the single maximum speed will automatically return to the real-time trip speed (km/h)
as shown in the image.
button (SW), the meter and the controller will turn off.
Definition
button shortly (UP) or the
2. Wheel Diameter
button (UP) or the
Hold the
There are 13 different diameters: 6,8,10,12,14,16,18,20,22,24,26,700 c and 28 inches. Hold the
your changes and enter the next setting.
3. Metric and Imperial Units
Hold the
metric/imperial units: speed, mileage and external temperature.
Display Metric
Riding speed Km/H
Total distance Km
Environment temperature ºC temperature
Error Code
05 info Axis speed sensor abnormality (only applies to torque sensor)
06 info Motor or controller has short circuit abnormality
button (UP) and the
button (DOWN) to set the maximum riding speed.
button shortly (SW) to save the current values and enter the next setting.
button (DOWN) to choose the necessary wheel diameter specifications.
button (UP) or the button (DOWN) shortly to set the three different
4. Hold the
Imperial
The speed and mileage units will then stop flashing. If you hold the
MPH
button (SW) shortly again, the maximum riding speed display
Mil
will appear. Alternatively, hold the
ºF temperature
2 seconds to exit the general settings interface and return to display 1.
Definition
button (DOWN) simultaneously for about 2 seconds.
button (SW) shortly to save
button shortly (SW) to save your changes.
button (SW) for about
Toll free/Sans frais: 1 800-661-3330
LCD METER
USER MANUEL
4