Assembly Requirements - Enerwatt EWV-RACER-BK-A Guide D'utilisation

3. ASSEMBLY METHOD AND REQUIREMENTS
3.3.3 Installing the brake cable
1. Insert the cable through the cable adapter barrel on the caliper.
2. Make sure that the cable housing is firmly sealed within the cable adjuster barrel, insert the end of the cable through
the anchor bolt on the caliper. Remove slack in the cable, then tighten the cable anchor bolt. Final tightening torque 6-8 Nm.
3. Adjust the screw of the brake lever to fasten or loosen the brake cable.
Note: Ensure there is no more than 20mm of excess cable beyond the anchor bolt.

3.5 Assembly requirements

In order to ensure cycling safety and performance, the fastening requirements
for the main bolts are listed in the table below:
NAME OF CLAMP BOLTS
Bolt for handlebar
Handlebar expander bolt
Handlebar stem and fork clamp bolt
Sunflower fixing bolt
Saddle
Seat post fixing bolt
Front wheel
Rear wheel
Rear rack
Derailleur
M5
1 bolt / 2 bolts
M6
M4
4 Bolts M5
M6
M8
M5
M6
M8
M4
M5
M6
M5
M6
M10
MODEL: EWV-RACER-BK-A
(CONTINUED)
3.4 Installing the mountain electric
bike handlebar
1. Take out the handlebar
2. Use the wrench to loosen
3. Insert the handlebar inside
4. Cover the handlebar clip,
STANDARD TORQUE / NM
10-12 Nm
12-15 Nm
4-6 Nm
6-8 Nm
8-10 Nm
12-15 Nm
15-18 Nm
8-10 Nm
10-12 Nm
4-6 Nm
10-12 Nm
15-18 Nm
8-10 Nm
10-12 Nm
12-15 Nm
25-30 Nm
40-45 Nm
6-8 Nm
8-10 Nm
8-10 Nm
USER'S MANUAL
and remove the protective
paper cover from the stem.
the screw counterclockwise.
the stem and adjust the
centred position.
then tighten the screws.
15