Basic Structure; Assembly Method And Requirements; Installing The Stem Group - Enerwatt EWV-RACER-BK-A Guide D'utilisation

2. BASIC STRUCTURE

1. Frame
2. Saddle post
3. Saddle
4. Stem
5. Handlebar
6. Derailleur
7. Brake lever

3. ASSEMBLY METHOD AND REQUIREMENTS

3.1 Installing the stem group

1. Place this ring on the stem
2. Add the golden wave ring,
then the front frame
3. Add another golden wave ring
4. Add a larger black ring
5. Add a thick black ring
6. Add a small ring
7. Add the thickest ring
8. Add all four of the same ring
9. Add the handle bar
10. Add this small part
11. Tighten the small part
12. Tighten the right and lift side
13. Add the black nut
First, check all the parts.
Then, assemble the pieces
as shown in the picture
(note the direction) and insert
the bolt from the top and
tighten the nut.
8. Front fork
9. Disc brake device
10. Disc brake
11. Hub
12. Rim
13. Tire
14. PAS sensor
1
5
8
12
15. Crank
16. Pedal
17. Chain
18. Flywheel
19. Motor
20. Spoke
21. Controller
2
6
10
9
13
MODEL: EWV-RACER-BK-A
22. Battery
23. Reflector
24. LCD display
25. Bell
3
7
11
USER'S MANUAL
4
13