Installing The Front Wheel - Enerwatt EWV-RACER-BK-A Guide D'utilisation

3. ASSEMBLY METHOD AND REQUIREMENTS

3.2 Installing the front wheel

3.2.1Installing the common front wheel
1
4
3.2.2 Installing the brake cable
1. Loosen the brake cable
2. Line up the brake device and the nut opening
3. Insert the cable
4. Screw and tighten the nut
5. Tighten and fix the cable
Readjust the brake if the cable isn't on both sides of the rim.
1 2
3.3 Installation of front brake
3.3.1 Mounting the rotor to the hub
1. Remove the wheel from the bike. Attach the rotor to the hub with the supplied Torx bolts and tighten with a T25 Torx wrench.
Tightening torque: 6.2 N.m.
2. Make sure the side with Tektro logo is facing out (the rotor must rotate in the same direction as the wheel set).
Tighten the rotor screw then install the wheel on the front fork or frame.
Note: The rotor must be installed with the "rotation" arrows pointing in the same direction as the forward rotation of the wheel.
3.3.2 Mounting the adapter and caliper
2
5
3
1. Mount the relevant adapter to the caliper body.
Insert 5 mm bolts through the two adapter slots on the body and screw into the holes on the adapter.
Do not tighten yet.
2. Mount the caliper body and adapter to the frame/fork by placing the slot in the caliper body
over the rotor. The mounting holes on the adapter should be behind the frame/fork mounting holes
(the hub side). Screw and tighten two 5 mm Allen bolts into the upper and lower holes in the
frame/fork mount. Final tightening torque: 6-8 Nm.
3. Check that the rotor is centred between the disc brake pads, and tighten the two bolts holding
the caliper to the adapter. To re-adjust the position of the caliper, loosen these
two bolts and slide the caliper over until it is centred on the rotor, then re-tighten the bolts.
Tightening torque: 6-8 Nm.
(CONTINUED)
3
6
4 5
MODEL: EWV-RACER-BK-A
1. Undo the quick release on
the front wheel, and loosen
the nut
2. Remove the little spring
3. Insert the centre axle
4. Adjust the front wheel
5. Lock the quick release
6. Finish installation
When fastening the nut on the
front wheel hub, press down the
front fork so that the front wheel
hub fits tightly into the front fork.
USER'S MANUAL
14