Functions And Display - Enerwatt EWV-RACER-BK-A Guide D'utilisation

1
Up button
2 Start/stop button (SW)
3 Down button
4
Battery capacity indicator
5
Backlighting and lights
6
Brake display
TM Single trip time
7
TTM Total trip time
Motor W Power display
8
Motor ºC Motor temperature
Motor ºF Motor temperature
ºC External temperature
9
ºF External temperature
OPERATION
1. On/Off
Hold the button (SW) to turn the meter on or off. The meter will automatically shut down when the vehicle has been stopped and the buttons haven't been
pressed for five minutes. The power supply of the electric vehicle will also be turned off. In power off mode, the meter and controller don't consume any power.
2. Display 1 :
This illustrated manual will help you understand how the meter works, how to operate the meter,
how to change the settings and how to improve the performance of the electric motor.

FUNCTIONS AND DISPLAY

10
6 km/h power assistant push
KM/H Riding speed (metric)
MPH Riding speed (imperial)
11
MXS Max speed
AVS Average speed
KM Distance (metric)
MIL Distance (imperial)
12
DST Trip distance
ODO Total distance
VOL Battery voltage
ASSIST Pas level
13
CRUISE Cruise function
Hold the button (SW) shortly to start up the meter and enter display 1.
2.1 Turn on the backlighting and lights
Hold the button (UP) and the meter will turn on the vehicle's back and front lights. The light logo will appear.
button (UP) again to turn off the lights.
Hold the
2.2 Assist gear ratio (assist switch)
Hold the button (UP) or the
This will change the motor output power. The gears can be switched between 1 and 5
(this can also be configured according to your requirements). Gear 1 = lowest power. Gear 5 = highest power.
2.3. 6 km/h power assist function
When you hold the button (DOWN), the meter assist function logo (
button (DOWN) and the assist function will be disabled.
Release the
2.4. Cruise Function
Hold the button (DOWN) to enter cruise mode. When the vehicle's speed is higher than 7 km/h, the cruise function logo
(CRUISE) will light up. Brake or hold any button to disable the cruise function.
2.5 Single Data Clearing
5 seconds after the meter is turned on, hold both the
2 seconds. When the single trip time (TM) and the single trip distance (DST) flicker, hold the
content will be cleared. If you don't hold the button for 5 seconds, the original content will be saved.
button (DOWN) to switch the power assist ratio (or throttle switch) gear.
button (UP) and the
LCD METER
) will flash, and the vehicle will drive at 6 km/h max.
button (DOWN) simultaneously for about
button shortly (SW), and the
USER MANUEL
3