V2 BLITZ-24V Instructions D'installation page 16

ACTUATOR FASTENING
As soon as the measures selected from the table, which is
on the previous page, have been marked on piers, proceed
with the following operations, considering figure 1 as a
reference:
• Fasten the anchor plate A to the pier by making use of
proper screws and blocks.
• Enter the ratiomotor into the anchor plate and fasten it
by means of screws B, washers C and nuts D supplied
(the shaft must be turned downwards).
• Assembly the articulated arm and the relevant bracket
as shown in the figure.
• Fit the articulated arm into the shaft and fasten the
screw E.
• Release the ratiomotor (see paragraph EMERGENCY
LOCK RELEASE).
• Mark the front bracket fastening points on the door
according to the previous established levels.
• Separate the front bracket F from the articulated arm.
• Fasten the bracket on the door by means of screws or
directly weld it in case the material it is made of allows
it.
Link the clamp F to the pivoted arm.
•
• Make several manual attempts in order to open and
close the doors by checking that no unwanted friction
occurs.
• Proceed with ELECTRICAL CONNECTIONS and
ADJUSTMENT OF STOP ENDS.
Insert the cap G, the plug H, the unclamping handle I
•
and fix the two screws.
m
WARNING: For the left actuator install the
motor as shown in fig.2 and repeat the above
operations.
FIG. 2
SX
FIG. 1
- 14 -
DX