Air Supply - Hyundai HHC2GNK Mode D'emploi

Operating Instructions
This 2-in-1 Brad Nailer/Stapler drives 18ga. brad nails from 5/8" to 1
1/4" (16-31mm) length and 18ga. staples from 5/8" to 1 1/4" (16-
31mm) length.

Air Supply

1. Use clean, dry and regulated compressed air at
60-100psi (4-7 bar).
2. Never exceed the maximum and minimum pressure. Pressure
that is too low or too high can cause premature misfiring.
3. When connecting the air supply always keep your hands and
body away from the discharge area of the tool.
4. A filter lubricator is recommended and should be located as
close to tool as possible.
5. Keep the air compressor's filter clean. A dirty filter will reduce
the air pressure to the tool causing a reduction in power and
efficiency.
6. Be sure all connections in air supply system are sealed using
PTFE thread sealant tape to prevent air loss.
29