Hyundai HHC2GNK Mode D'emploi page 28

all times to safeguard against possible injury.
• DISCONNECT TOOL FROM AIR SUPPLY BEFORE LOADING
fasteners to prevent a fastener from being fired during loading.
• DO NOT KEEP THE TRIGGER OR SAFETY DEPRESSED during
fastener loading or the unintentional firing of a fastener can
cause personal injury.
• DISCONNECT TOOL FROM AIR SUPPLY HOSE and turn off the
compressor before performing any maintenance.
• DO NOT DRIVE FASTENERS CLOSE TO THE EDGE OF THE WORK
PIECE. The work piece can split allowing the fastener to fly free
or ricochet causing personal injury.
• DO NOT DRIVE A FASTENER ON TOP OF A PREVIOUSLY NAILED
FASTENER or the fastener can potentially ricochet causing
personal injury.
• DO NOT HOLD A WORK PIECE NEAR WHERE YOU ARE FIRING.
Nails, staples and other fasteners can deviate from their course
and exit out the side of the work piece.
• NEVER USE A TOOL that is leaking air, has missing or damaged
parts or requires repair. Also, make sure all screws and fasteners
are secure and tight.
• PERFORM A DAILY INSPECTION FOR FREE MOVEMENT of trigger,
safety mechanism and spring to ensure the tool is in operating
condition.
• ONLY USE PARTS AND ACCESSORIES recommended by Hyundai.
28