Hyundai HHC2GNK Mode D'emploi page 16

4. Turn the power switch to the ON position.
5. Allow the compressor to run for approximately 15 minutes.
6. Close the drain valve, allowing pressure to build to the
maximum cut-out pressure. The compressor will shut off
automatically.
7. Use the compressed air in the tank with an approved
attachment or allow it to bleed out.
Start-up
1. Make sure the regulator knob is turned counter-clockwise.
2. Plug the power cord into a properly grounded power outlet.
3. Turn the power switch to the ON position.
4. Allow the compressor to reach the maximum cut-out pressure.
The compressor will shut off automatically.
5. Attach a hose and the desired accessory to the unit.
6. Adjust the regulator knob to the desired pressure.
16