Aqua Medic BLENNY advanced Mode D'emploi page 5

1. Product description
Following parts are included:
- Aquarium 40 x 50 (incl. filter chamber) x 40 cm
- Skimmer EVO 500
- Current pump EcoDrift 4.1
- Illumination aquareefLED with holder
- Filter separating wall
- Filter basket for taking up activated carbon or phosphate absorbers
A timer and a socket board are not included.
2. Set-Up of the aquarium
The aquarium can be placed directly on a sufficiently solid cabinet or desk. Beforehand, the cabinet
plate and the lower surface of the aquarium should be cleaned to prevent the bottom pane of glass
from bursting through grains of sand or any dust particles.
First of all, the aquarium has to be cleaned with clear water. Afterwards, the protective plastic film
has to be pulled off the black plastic rear wall (if applicable).
The lower edge of the rear wall has a lip made of self-adhesive foam rubber. Wipe any fingerprints
off the lower edge by using a dry cloth. Remove the protective plastic film from the self-adhesive
strip, apply and remove any excess rubber.
Now, push the rear wall into place.
3. Current pump EcoDrift 4.1
See attached manual.
The pump is open at the front. Therefore, it should never be started uncontrolled, e. g.
via a time switch. Animals could be in the sucking in basket and they could be injured or killed by
the starting propeller.
There is an opening at the rear wall for inserting the current pump. First, insert the rubber O-ring
into the hole of the filter chamber (not from the aquarium side). Now, the pump has to be pushed
into the retaining O-ring.
4. Skimmer EVO 500
See attached manual.
The skimmer is hung on the middle separating wall of the filter chamber without holder. The pump
basket has to be removed.
Available spare parts: Please refer to www.aqua-medic.de.
5. Illumination
LED Illumination aquareefLED with holder (see separate manual)
5