Human Touch HT-Reflex 8 Manuel D'utilisation Et D'entretien page 4

get ready
humantouch.com
1. Plug it in
Plug the power cord into an appropriate power source.
2. Power on
Turn the master power switch (on the rear lower right-hand corner of the massager) to On.
3. Position your foot and calf massager in front of your favorite chair.
4. Take a seat.
4
Intensity adjust
5. Adjust the calf massage intensity.
Place your feet all the way into the foot and calf massage wells
then turn the calf intensity adjust knob toward you to increase
massage intensity or away from you to decrease intensity.
6. Adjust the massager angle.
Push the angle adjust lever forward, then use your feet
to adjust the massager angle as desired. Pull the angle
adjust lever backward to lock it into position.
Angle adjust
NOTE: Follow the below steps to remove your feet from the unit in
the event of a power failure:
1. Lift your knees upward (Fig. 1).
2. Rotate your feet sideways and ease them out (Fig. 2).
Sitting or standing on your foot and calf massager could result in personal injury and or permanent damage to the massager.
Your foot and calf massager
fully assembled. Simply plug it in,
take a seat, adjust the intensity
and angle, and you're set to go!
Fig. 1 Fig. 2
5
comes