Getting Started - Inficon GAS-Mate Mode D'emploi

W A R N I N G
The GAS-Mate will detect leaks as described below but may not
indicate when a hazardous atmosphere is present due to its Auto
Zeroing function. Lack of a reading by the GAS-Mate should not
be taken as an indication that the atmosphere is totally safe.
W A R N I N G
There are no user serviceable parts inside. Do not disassemble
the GAS-Mate.

Getting Started

1. The combustible gas sensor is already installed in the GAS-Mate's probe.
No installation of the sensor is necessary.
2. You will need to install the alkaline batteries which are included with your
GAS-Mate. Remove the battery cover by releasing the latch and sliding the
cover down and off the handle. You may need to use a small flat-blade
screwdriver to assist with releasing the latch. Install the two "D" sized Duracell®
MN1300 alkaline batteries as shown in
pointing toward the end of the handle. Reinstall the battery cover by aligning it
in the grooves on the handle and sliding it up the handle until it latches.
Figure 1 Properly installed alkaline batteries
+
DURACELL® is a registered trademark of Duracell, Inc., Bethel, Connecticut.
- +
5
Figure 1, with the positive terminals
-