Emc Compliance - Brecknell LPS Serie Mode D'emploi

1.2 Warnings
DANGER: FOR YOUR PROTECTION, ALL MAINS (110V OR 230V)
EQUIPMENT USED WHERE DAMP OR WET CONDITIONS MAY OCCUR
MUST BE SUPPLIED FROM A CORRECTLY FUSED SOURCE AND
PROTECTED BY AN APPROVED GROUND FAULT PROTECTION
DEVICE (RCD, GFCI ETC).
DANGER: RISK OF ELECTRICAL SHOCK. BE SURE TO UPLUG THE
INDICATOR BEFORE REMOVING THE COVER OR OPENING THE UNIT.
REFER TO QUALIFIED SERVICE PERSONNEL FOR SERVICE.

1.3 EMC Compliance

The following warning may be applicable to your machine.
CAUTION!
This is a Class A product.
In a domestic environment this product may cause radio interference in which
the user may be required to take adequate measures.
United States
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
4
Read all operating instructions carefully before use.
l
Avoid lengthy exposure to extreme heat or cold. Your scale works best when
l
operated at normal room temperature. Always allow the scale to acclimate to
a normal room temperature before use.
Allow sufficient warm up time. Turn the scale on and wait for a few minutes if
l
possible. This will give the internal components a chance to stabilize before
weighing.
These electronic scales are precision instruments. Do not operate near an
l
in-use cell phone, radio, computer or other electronic device. These devices
emit RF and can cause unstable scale readings.
Avoid using in heavy vibration and airflow conditions.
l
Read the weight shortly after loading. The output of the loadcell and A/D
l
may be a little influenced after weight sits for a long time.
LPS Series User Instructions