Keys; Performing A Weighment - Brecknell LPS Serie Mode D'emploi

3.3.1 Keys

The keyboard consists of four keys, some of which have multiple functions.
Key
This key can be configured so it operates as a hold key only, operate as a print key only or operate
as both.
All units of measure within the scale should be able to be enabled / disable through the
configuration mode.
When the unit's key is pressed the scale will automatically switch to the new unit of measure and
display the correct weight, even if there is a hold or tare is active.
Press the tare key to tare the weight on the scale. The net annuncator will illuminate.
To cancel a tare, press the tare key with no weight on the scale.
Press this key to turn the scale on. The display will show the scale's ca- pacity, the scale will
automatically zero if the weight is within 10% of the calibrated zero point, and then 0 (kg/lb) will be
displayed. This is normal weighing mode.
The scale powers up in the same unit of measure as when it was turned off.
Press this key to zero any weight, up to 2% of full capacity, on the scale.
Press and hold this key for five seconds to turn the scale off.

3.3.2 Performing a Weighment

1.
2.
3.
4.
10
Figure 3.1 LPS Series Keypad
Table 3.1 Function of the Keys (normal working mode)
Turn the scale on and press the ZERO key if the display shows any weight.
Place item on the scale. Weight is displayed.
Press the TARE key to tare a weight.
Press UNITS key to change unit of measure.
Function
LPS Series User Instructions