Pattfield Ergo Tools PE-160KS Traduction De La Notice Originale page 62

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
CUTTING DEPTH
1
Pull the cutting depth locking lever
upwards.
Caution! Make sure the tool is
switched off and unplugged.
MITRE CUTS
1
Open the angle clamping knob 16.
Caution! Make sure the tool is
switched off and unplugged.
SAW BLADE REPLACEMENT
1
Press the spindle lock
pin 18
and loos-
en the saw blade clamp
washers 6
the hex key anti-clockwise.
Caution! Make sure the tool is
switched off and unplugged and
wear protective gloves.
3
Place a new saw blade upon the inner
washer (printed side pointing outward)
and close the saw blade safety guard 8.
Caution! Observe that the rotation
direction of the saw blade corre-
sponds with the tool.
LASER BATTERY REPLACEMENT
1
Open the laser battery
compartment 20
with a cross-head screwdriver.
Caution! Make sure the tool is
switched off and unplugged.
122
EN
11
2
Set the desired cutting depth and press
down the cutting depth locking lever
to secure it.
2
Set the desired angle and tighten the
angle clamping
knob 16
securely.
2
Open the saw blade safety guard 
with
pushing the saw blade guard knob 
clockwise and remove the saw blade 5.
Make sure to keep the inner washer at
its place.
4
Press the spindle lock
pin 18
tighten the saw blade clamp
with the hex key.
Caution! The mounting flange of the
big washer must point outwards.
2
Insert two button cells as indicated.
Afterwards close the laser battery
compartment 
20
with a cross-head
screwdriver.
1
11
1
8
1
4
1. 1.
again and
3
washers 6
1
2. 2.
2
2
2
2. 2.
2. 2.
4
1. 1.
2
1. 1.
1. 1.
2. 2.
EN
123

Publicité

Table des Matières
loading

Table des Matières