Springlane Mila Mode D'emploi page 26

lid and plug in a dishwasher, to avoid
damaging the seals.
4. Also regularly clean the metal pins pro-
truding into the mixing chamber, the
silicone valve through which the water
flows into the mixing chamber, as well
as the silicone spout with a damp cloth.
5. Regularly clean the water container to
make sure it always stays hygienically
clean.
6. Clean the housing with a damp and soft
cloth and thoroughly dry afterwards.
WARNING: If you wish to
clean the blades by hand,
switch off the device and remove
the mains plug. Please pay attenti-
on and be careful, the blades are
very sharp.
Do not disconnect the
power supply of the appli-
ance during the cleaning program-
me and do not interrupt the
programme.
REMOVE RESIDUES FROM
THE MIXING CHAMBER
Please follow these steps if you wish to
remove any residues or unfinished milk
left in the mixing chamber due to a power
outage or for a different reason:
26
All manuals and user guides at all-guides.com
1. Connect Mila to the power supply.
2. As soon as the display shows all sym-
bols, you can have the rests fed out by
holding the "Capacity" button.
3. Afterwards, start a manual cleaning
programme using the "Cleaning"
button.
DESCALING
Treat Mila with care and only use filtered
water. You should additionally descale
Mila regularly. We recommend descaling
after every 50th preparation process, or
whenever you clearly notice limescale on
or in the machine. To descale, proceed as
follows:
1. Add 3 tsp baking soda into the water
container and fill it with water.
2. Run through a preparation programme
without any ingredients using a quantity
of 300 ml.
3. Abort the preparation by removing the
water container. Drain the remaining
water with baking soda. Wait for 1 hour
and reinsert the water container with
fresh water. Now, allow the programme
to finish.
4. Afterwards, run through two preparation
programmes without any ingredients
using a quantity of 1,000 ml each time.
Repeat the process, if required. Now,
Mila is good to go.