Shop-Vac BP Serie Manuel D'utilisation page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6. Position left shoulder pad along back plate so textured section is
facing down and smooth side is facing up. Make sure there are no
twists in shoulder strap.
7. Straighten shoulder strap above left shoulder pad so there are no
twists in strap. Slide strap into top hole on left side of back plate.
8. Fold strap over top of back plate and slide end of strap into top
slot in strap adjuster so you can still see top section of adjuster.
9. Slide end of strap into bottom slot in strap adjuster so you can
still see bottom section of adjuster.
10. Repeat steps 6 to 9 using right shoulder pad, right shoulder strap
and top hole on right side of back plate.
11. To install the back plate and harness assembly to the tank refer to
the Installing Back Plate and harness Assembly section in this
manual.
PAGE 6
ASSEMBLY (CONT'D.)
ShOULDER
PAD
ShOULDER
STRAP
STRAP
ADJUSTER
ShOULDER
STRAP
STRAP
ADJUSTER
STRAP
ADJUSTER
BACK
PLATE
BACK
PLATE
BACK
PLATE
ShOULDER
STRAP
BACK
PLATE

Publicité

Table des Matières
loading

Table des Matières