Tripp-Lite B320-4X1 Serie Manuel De L'utilisateur page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
Refer to the following steps and diagram to set up your 4-port presentation
switch installation.
Installation Instructions for B320-4X1-HH-K1 &
B320-4X1-HH-K2
Notes:
1. Test to ensure the entire installation works properly before pulling
cables through ceilings/walls.
2. To achieve maximum distance and performance, use 24 AWG solid-
wire Cat6 cables. Using stranded-wire Cat6 cable or cable with a gauge
(AWG) size higher than 24 AWG will result in shorter extension distance.
Higher-gauge cabling, such as 26 AWG, has more limited transmission
capability than lower-gauge cabling. All Tripp Lite N202-Series Cat6
cables are made with 24 AWG solid-wire cabling.
3. External power is not required for remote receiver units, due to PoC
technology incorporated in the transmitter units.
B320-4X1-HH-K1
& B320-4X1-HH-K2
extender kit
SWITCH
20-05-025-933CA4.indb 7
20-05-025-933CA4.indb 7
Up to 50 ft. (15 m) Cat6 cable at 4K/60Hz
Up to 125 ft. (38 m) Cat6 cable at 4K/60Hz
Up to 15 ft. (4.5 m) HDMI 2.0 cable at 4K/60Hz
RS-232 cable
7
RECEIVER
10/21/2020 9:26:38 AM
10/21/2020 9:26:38 AM

Publicité

Table des Matières
loading

Table des Matières