Safety Instructions - ATIKA BioLine AH 200 Notice D'utilisation

2. Safety Instructions

Machine including safety cut-out
The safety cut-out, including an automatic motor
brake, which is attached to the shredder is used
for the safety of the machine, preventing the
motor being started when the machine is open
and the rotating knives could be reached by the
operator's hand.
Repairs on electrical parts of the machine and
on the safety cut-out must be done by the
producer or by a company designated by the
producer.
Please read the following
safety instructions carefully.
• Within his area of work the operator is
responsible for third parties.
• The machine must not be used by opera-
tors under the age of 16.
• Keep children away form machine.
• Wear protective goggles, gloves and noise
protection while working with the machine.
• The connecting lead to IEC 60245
(H 07 RN-F) should be equipped with a
rubber plug. The lead section should be
a minimum of 3 x 1,5 mm².
• Never use faulty connecting leads.
• Connect the machine using a residual
current petector.
• Always switch off motor before main-
tenance and cleaning of shredder.
Remove mains plug from socket (also
during transport and when leaving
machine unattended).
• Do not operate without the funnel.
• Close machine properly before enabling
motor.
• Faulty or damaged parts in the device
must be replaced immediately.
• Never reach into the filling or ejection
opening when the machine is running.
• Do not spray machine with water (this
is hazardous due to live components).
• Wear safety gloves during assembly
and cleaning work.
• Never modify the machine or parts thereof.
• Only use the machine for the purposes
listed under Section 4 "Shredding".
• Do not leave the machine standing in
the rain or use when raining. Store the
machine in a dry place.
20
• To prevent danger of injury to fingers during
assembly or cleaning operations hold the cut-
ting mechanism (for example by means of a
wooden wedge, see. pic. p. 21) and wear
protecting gloves.
3. Start-up
• Check that the machine is completely and
correctly assembled.
• To avoid toppling, place the chopper on a firm
horizontal surface.
• Connect the machine to an appropriate and
correctly wired electric socket.
• Only use extension leads with sufficient dia-
meters:
- cable up to 25 metres: diameter at least
1,5 mm².
- cable over 25 metres: diameter at least
2,5 mm².
• Fuse protection:
- 1100 W, 1200 W:
- 1300 W, 1400 W, 1500 W,
1600 W, 1700 W:
- 1800 W, 1900 W, 2000 W:
- 2100 W, 2200 W, 2300 W
2400 W:
- for UK use 13 A fuse (all models)
• Before using the shredder, make sure each
time that
- there are no faulty connections (tears, cuts,
etc.)
- all screws are tight.
Important:
Before using the shredder for the first time,
close top of case and screw tight.
Switch on and off
10 A
10 A inert
16 A
16 A inert