General Operation; Operating Temperature - Oregon ST275 Manuel D'instructions Original

OPERATING THE TRIMMER/EDGER

GENERAL OPERATION

CAUTION: TO REDUCE THE RISK
OF INJURY, ALWAYS WEAR PROPER
EYE AND EAR PROTECTION, LONG
PANTS, AND FOOT PROTECTION.
IMPORTANT: USE CARE AROUND
STRUCTURES, TREES, AND BUSHES TO
AVOID DAMAGING PAINT OR BARK.

OPERATING TEMPERATURE

This trimmer/edger is designed to
operate within a temperature range of
32°F to 104°F (0°C to 40°C)
IMPORTANT: THE TRIMMER/
EDGER IS EQUIPPED WITH A
TEMPERATURE SENSOR THAT
STOPS THE MOTOR TO PREVENT
THERMAL OVERLOAD DAMAGE.
IF THE TRIMMER/EDGER STOPS
WORKING SUDDENLY, IT MIGHT BE
TOO HOT TO CONTINUE RUNNING.
ALLOW THE TOOL TO COOL BEFORE
CONTINUED OPERATION. SEE
"TROUBLESHOOTING" FOR MORE
INFORMATION.
GRIP
The front handle on the trimmer/edger
handle is adjustable You can move the
handle forward or backward along the
shaft until it is in a comfortable position
for trimming, clearing, or edging
16
OREGON® Cordless Tool System
TRIMMER/EDGER MODEL ST275
Loosen the adjustment knob until the
front handle slides along the shaft, move
the handle to a comfortable position,
and then tighten the adjustment knob
(Fig 15)
FIG. 15
When using the trimmer/edger, grip both
the front and rear handles firmly
FOOTING
Stand or walk with both feet on solid
ground Do not overreach
STOPPING THE TRIMMER/EDGER
Release the throttle trigger to stop the
trimmer/edger
STARTING THE TRIMMER/EDGER
Grasp the front and rear handles firmly
Squeeze the trigger lock-out (1), then
squeeze the throttle trigger (2) until the
trimmer head moves at the desired
speed (Fig 16)
FIG. 16
(1) TRIGGER LOCK-OUT
(2) THROTTLE TRIGGER
AA 1013 - F/N 564572