Adjustable Deck Support Installation - MINN KOTA TALON TILT BRACKET Mode D'emploi

ADJUSTABLE DECK SUPPORT INSTALLATION

1. Remove the top cover from the Talon using a #2 Phillips screw driver as seen in Illustration 3 above. There are a total of 4
screws holding the cover in place.
2. Install the leg tip support on the port (left) side of the Talon by loosening the square nut until it is flush with the end of the
screw. Slide the support into the channel making sure the washer is on the outside of Talon and the square nut is on the inside
of the slot. Position the leg tip support against the top edge of the motor cover for now. The final position of this support will
be determined later. NOTE: The adjustable deck support can only be mounted on the port (left) side of Talon as in Illustration
4 above.
3. Install the deck support pivot by loosening the square nut until it is flush with the end of the shoulder bolt threads. Slide the
support into the side channel of Talon making sure the washer is on the outside of Talon and the square nut is on the inside of
the slot. The installed deck support pivot will already have the support leg installed and should look similar to Illustration 5
above when installed. Do not completely tighten any of the fasteners at this step.
4. Now reinstall the Talon cover that was removed in step 1. Tighten all four screws securely.
5. Loosen the support leg locking screw until the support leg moves
freely as shown in Illustration 6 below.
6. In the next few steps we will be adjusting the position and length
of the support leg. In order to determine the best position for
the support leg release the Talon Tilt Bracket by pressing on the
release lever as pointed out in Illustration 7 to the right.
7. Pull out on the deck support pivot first and then rotate 90
degrees as seen in Illustration 8 to the right. The pivot will lock
into its "in use" position.
©2013 Johnson Outdoors Marine Electronics, Inc.
Leg Tip Support
Illustration 3
Support Leg
Locking Screw
Illustration 6
Illustration 4
INSTALLATION
Deck Support Pivot
Illustration 5
Illustration 7
minnkotamotors.com | 7