MINN KOTA TALON TILT BRACKET Mode D'emploi page 8

8. Pivot Talon down and:
a. Position the support leg pivot along the length of Talon in the best
location for your boat (see dimension "a" on illustration below). Tighten
the support leg pivot into place using the ¼" Allen wrench.
b. Adjust the leg length to one of the machined slot locations that works best and retighten
the locking screw that was loosened in step 5 (see dimension "b" on Illustration 9 below).
9. Adjust the leg tip support position according to your adjusted leg support length, so that the
end of the leg will rest in the cradle. Tighten the leg tip support using a 7/32" Allen wrench.
10. Tilt Talon up to normal operating position and verify that the tilt bracket locks.
11. Next, pull out and pivot the deck support back to its stowed position
into the leg tip support.
12. After final adjustments to the length of the support leg, any extra
length can be cut off just above the deck support pivot (as seen in
Illustration 10) using a standard hand saw.
8 | minnkotamotors.com
a
b
Illustration 9
Cut to length
INSTALLATION
2
1
Illustration 8
Illustration 10
©2013 Johnson Outdoors Marine Electronics, Inc.